Many customer wonder why hydrostatic level sensors fail due to lightning strikes, even if they ordered an even sensor with integrated lightning protection. Focusing on how the lightning protection works and how lightning strikes affect hydrostatic level sensors is essential in resolving this confusion.
When submersible pressure sensors, a particular type of hydrostatic level sensors, were first installed into reservoirs and lakes to monitor level, the sensor would become burned or destroyed after a lightning storm or inclement weather periods. This prompted much research in to the effect of lightning storms on the instrumentation in reservoirs and the cabling to and from the website.
What lightning protection really means
The first thing to understand is that the result of a lightning strike is considerably different based on how near to the pressure sensor the lightning strikes into the ground or installation. It is fair to state that no level sensor will survive a direct or very close nearby lightning strike, where usually the whole cabin including all installed electronics will undoubtedly be incinerated by direct hits.
However, more distant hits will only raise the Voltage differential by for instance 1500 Volts. In case a local lightning strike raises the electric potential of a reservoir, the particular level sensor might provide the shortest way for the raised voltage and current to earth. The power will then dissipate in to the ground via the particular level probe and thus destroy or damage its electronics. This may equally function as case when overhead wires have a hit.
So how exactly does lightning protection in level sensors work?
However, sensors can be protected from these lightning strikes by installing or integrating a transient voltage protection in to the hydrostatic level sensor. As a result of short nature of the voltage pulse, an element may be fitted to or integrated into the sensor that acts on rising differences in voltage potential. If the voltage goes above say 50 Volts, this lightning protection can short-circuit the electronic circuit to ground, allowing a way to ground for the surge and protecting the electronics around the maximum specified voltage potential.
The component would normally operate in a non-conductive state, but will undoubtedly be conductive for a voltage transient, allowing the voltage spike to flow harmlessly to ground. If the connection to earth is not sufficient or no lightning protection is integrated within the hydrostatic level sensor, then your electronics will take the full amount of energy of the voltage pulse and fail.Therefore the protection is only as effective as the earth grounding provided by the user.
In outdoor applications, where submersible pressure transmitters are commonly used, WIKA provides an optionally integrated lightning protection inside the level sensors. The sensor electronics will be protected from local power surges and transient high voltage. Sleeping is really a combination of protection within the instrument and a good low impedance earth grounding.
Check out Quadruple of WIKAs submersible pressure transmitters LH-20 and LH-10.
Please use our contact form if you want further assistance.
Please find further information on this topic on our information platform ?Hydrostatic level measurement?